How To Repair Cracks In Formica

How to Repair Cracks in Polyethylene

past C.L. Rease

motorcycle epitome by Aleksander from Fotolia.com

Polyethylene has made its manner into many components of cars, motorcycles and boats. Although strong and lightweight, polyethylene is not impervious to cracking. When a polyethylene part cracks, you need to repair the function immediately to reduce the chances of the crack growing and ruining the polyethylene part. Advertised quick epoxy fixes for polyethylene parts will concur temporarily, but they will not create a permanent repair on the part. Welding the cleft will permanently repair it, and it will also strengthen the damaged area, eliminating the chances of the crack returning.

Step 1

Ready the temperature of the plastic welder to 575 degrees Fahrenheit, turn the welder on and set it aside to allow the plastic welder to reach the correct welding temperature.

Step 2

Wipe the expanse effectually the polyethylene crack with a clean rag to clear the crevice and the area surrounding the crack of materials that could contaminate the weld articulation.

Stride iii

Put on your safe glasses.

Pace 4

Bevel one side of the crack in the polyethylene part to a depth at to the lowest degree 1/viii inch deep. Make sure that you bevel 1/2 inch by each cease of the cleft.

Stride 5

Align the speed tip of the plastic welder with the beveled finish of the crack that is furthest away from y'all. Slide one end of the polyethylene filler rod into the guide of the plastic welder's speed tip.

Step half dozen

Apply downward force per unit area on the length of polyethylene filler rod, as you pull the plastic welder toward you slowly. Watch the area where the polyethylene filler rod meets the surface of the askew polyethylene crack. If yous notice a small bead of melted polyethylene flowing alee of the filler rod and the polyethylene is not burning, you are pulling the plastic welder at the correct speed.

Step seven

Cut the polyethylene filler rod even with the end of the speed tip guide, when you are 1 inch abroad from the end of the cleft you are repairing. Go along pulling the plastic welder toward you to fuse the balance of the polyethylene rod to the surface of the polyethylene repair.

Step viii

Allow the polyethylene repair to cool thoroughly before continuing.

Step 9

Attach the 120-grit sandpaper to the palm sander.

Step 10

Sand the polyethylene filler rod smooth with the surface of the polyethylene part to blend the repair into the part.

Repeat the process to repair the behind of the polyethylene scissure, to complete the polyethylene fissure repair.

References

Things You'll Demand